Acer C101i Manuale Utente Scaricare il pdf (Pagina 7)

Size：105 x 140mm / 80P模造紙 / 黑白單色印刷 / 膠裝

EN-6

Charging LED Indicator

During charging, the LED indicator lights will flash as marquee. While the battery is fully

charged, the LED indicator lights turns to solid blue.

Adjusting the Focus

Place the projector on a flat surface and toward a wall or

a projection screen. Adjust the focus by turning the focus

ring to get a sharp and clear picture.

LED Status Indication

Note: Use a tripod to increase the height of the projectional image when necessary.

The tripod socket is located under the projector.

Power On / Off / Standby

Push the Power button for 2 seconds to turn on the projector.

Push the Power button again for 3 seconds to turn off the projector.

Standby mode: Push the Power button for 1 second to turn on / off the projector lamp to

save the battery and system reboot time. (The LEDs are still on when the projector is in

standby mode.)

Adjusting the brightness of projector

There is a brightness adjustment button on the top of the projector. It allows you to change

the brightness.

Main Screen

Power on the projector, the following

screen appears after the projector

boots up.

3 blue LEDs stay on Power capacity is between 80% to 100%

2 blue LEDs stay on Power capacity is between 45% to 80%

1 blue LED stays on Power capacity is between 10% to 45%

1 blue LED blinks Power capacity is below 10%

LED Marquee Projector is being charged

Mode

Normal

Eco

Brightness

High

Low

Battery Power (HDMI mode)

70 mins

120 mins

1 2 3 4 5 6 7 8 9 10 11 12 13

Nessun commento

Acer C101i Manuale Utente Pagina 7